About two years ago Elaine bought Sonya’s old windmill, with plans to place it over one of the old wells on the ranch so that it could pump water for a stock tank for wildlife. Ever since then we’ve been trying to get one of the local well-maintenance people to move the windmill from Sonya’s, repair the pump in the well, and erect the windmill. Finally last week one of the drillers came by and committed to completing the project. The first step is for us to install footings for the tower. These will be cast concrete, three feet deep. I started digging the holes for the Sonotube forms on Monday. The well is about 100 yards off of the side road that crosses the ranch and required some “cross-country” driving to reach the well. Although I detoured around the old fencing, there apparently was a cache of old fence wire buried in the brush that I driving over. The wire wrapped itself quite thoroughly around the right front axle and the drive shaft as well. After trying various approaches to removing the wire I finally grabbed my angle grinder and put a cutting wheel on it. I was able to separate the wire into two large chunks that I could pull out over the hub. (I had already removed the wheel.) Needless to say, future visits to the site involve a more careful search for residual wire.